Southern Performance Systems
Now Accepts these
Major Credit Cards
|
Our Installation Department has been hard at work
on a 1989 Chevy Pickup Truck owned by Bill
Aumack. The truck is receiving a 2009 5.3L Vortec
Engine 325HP with 4L60E Transmission to replace
it's old 350 Small Block Chevrolet Engine and 700R
Transmission. For the Engine Swap/Installation we
used custom BRP Frame and Motor Mounts along
with new Crossmember. Custom BRP Long Tube
Headers were used to clear the truck's frame and
upper control arms. The truck's rear end was
updated with a 3.73 Posi Unit. More Information will
be posted at the job continues.
We Install What We Sell. Call for Details.
Original 350 Small Block Engine Prior to Removal
|
Engine Compartment Prior to Clean Up and Paint
|
Engine Compartment Painted Black with Clear Coat
|
Old with the Old and in with the New
|
New 2009 GM 5.3L Vortec Engine Mounted in Engine Compartment
|
New Custom BRP Headers to use with an LS Series Engine in a 1989 Chevy Truck
|
Installation and Service Supervisor, Tiny, checking Frame to Engine Clearance for new
Headers
|
View from Rear of Truck 4L60E Transmission Shown at Center of Photo
|
View of Passenger Side Header
|
View of Rear End Prior to Removal
|
View of Wheel Well with Rear End Removed
|
Rebuild Rear End Installed
|
Rebuild Rear End Installed
|
4L60E Transmission and Exhaust Headers
|
View of Oil Pan-4L60E Transmission-Exhaust Headers
|
Custom Mounted Electronic 'Drive by Wire' Pedal Assembly
|
Finished Custom Mounted Electronic 'Drive by Wire' Pedal Assembly
|
Custom Lokar Floor Shifter
|
Custom Lokar Floor Shifter with Boot
|
View of New Custom Installed Exhaust System
|
Another View of New Custom Installed Exhaust System
|
View of Crossmember with Custom Exhaust System
|
Custom Exhaust and Rear End
|
Another View of Custom Exhaust Tip
|
Engine Compartment Close to Being Finished
|
View of Engine Compartment from Passenger Side
|
Mounted Custom A/C Compressor Required due to Frame Clearance Issues
|
Custom Build Radiator with Electric Fan
|
Another View of Radiator and A/C Compressor
|
Fuel Filter with Built-in Return
|
Braided Fuel Line with Bracket to Clear Headers
|
Various Mounts were made including this one used to hold the transmission oil lines between
the Cooler and the Transmission
|
Custom Radiator with Water Temperature Sender for Electric Fan
|
Custom Painted Intake Cover and Air Cleaner
|
Custom Painted Intake Cover and Air Cleaner
|
Custom Painted Intake Cover and Air Cleaner
|
Completed 1989 Chevy Truck
|
